rockbox/firmware/target/arm/system-pp502x.c, branch master

move PP specific files to pp/

2012-01-03T04:39:56+00:00

git-svn-id: svn://svn.rockbox.org/rockbox/trunk@31533 a1c6a512-1295-4272-9138-f99709370657

usb-target.h: remove

2011-12-31T18:44:55+00:00

git-svn-id: svn://svn.rockbox.org/rockbox/trunk@31498 a1c6a512-1295-4272-9138-f99709370657

Commit to certain names for cache coherency APIs and discard the aliases.

2011-12-17T07:27:24+00:00

Wouldn't surprise me a bit to get some non-green.


git-svn-id: svn://svn.rockbox.org/rockbox/trunk@31339 a1c6a512-1295-4272-9138-f99709370657

Add a higher level USB detection that prevents fraudulent bus resets from causing USB mode to be entered. Enable for SA9200 only at this time. Also, for SA9200, use the bus power GPIO rather than the 'connector inserted' GPIO to detect the cable.

2011-01-17T12:24:41+00:00

git-svn-id: svn://svn.rockbox.org/rockbox/trunk@29068 a1c6a512-1295-4272-9138-f99709370657

Convert PortalPlayer iRivers to use USB-mode enabled bootloader. The H10 5/6GB already has a pre-boot USB mode (so it's a little redundant there) but building them the same way is simpler.

2011-01-17T06:50:27+00:00

git-svn-id: svn://svn.rockbox.org/rockbox/trunk@29067 a1c6a512-1295-4272-9138-f99709370657

Bootloader USB mode for PP502x. Enable only on GoGear SA9200 for the time being. Add HAVE_BOOTLOADER_USB_MODE to config if BOOTLOADER is defined to enable it. Clean up some kernel stuff a little to support it. Mess up a bunch of other stuff (hopefully not too badly).

2011-01-15T08:19:30+00:00

git-svn-id: svn://svn.rockbox.org/rockbox/trunk@29053 a1c6a512-1295-4272-9138-f99709370657

Forgot to rename cpucache_flush/_invalidate for PP502x.

2010-09-09T14:35:47+00:00

git-svn-id: svn://svn.rockbox.org/rockbox/trunk@28053 a1c6a512-1295-4272-9138-f99709370657

ipodvideo: detect ram size at boot (doesn't actually get USED yet)

2010-08-29T13:20:16+00:00

This is the first step to allowing a single build which will work on any ipodvideo.

A global variable, probed_ramsize, is initialised to either 32 or 64 early in boot.


git-svn-id: svn://svn.rockbox.org/rockbox/trunk@27937 a1c6a512-1295-4272-9138-f99709370657

Packard Bell Vibe 500: reset all allowed devices like in the OF.

2010-03-09T19:09:17+00:00

git-svn-id: svn://svn.rockbox.org/rockbox/trunk@25089 a1c6a512-1295-4272-9138-f99709370657

Add initial Packard Bell Vibe 500 port, by Szymon Dziok

2010-01-18T19:05:20+00:00

Author: Szymon Dziok 
Flyspray: FS#10912


git-svn-id: svn://svn.rockbox.org/rockbox/trunk@24276 a1c6a512-1295-4272-9138-f99709370657