Add a blind description for the Sansa Fuze and e200v2 manuals.

git-svn-id: svn://svn.rockbox.org/rockbox/trunk@23315 a1c6a512-1295-4272-9138-f99709370657

1 files changed, 19 insertions, 1 deletions

diff --git a/manual/rockbox_interface/main.tex b/manual/rockbox_interface/main.tex
index c58f3e6..d992fde 100644
--- a/manual/rockbox_interface/main.tex
+++ b/manual/rockbox_interface/main.tex
@@ -313,7 +313,7 @@ described in detail in the following paragraph.
   remote connector.  Below this is a cover which protects the \opt{x5}{USB host
   connector.}\opt{m5}{USB and charging connector}.}
   %
-  \opt{e200}{
+  \opt{e200,e200v2}{
   Hold the \dap{} with the turning wheel at the front and bottom.  On the bottom left
   of the front of the \dap{} is a raised round button, the \ButtonPower{} button.
   Above and to the left of this, on the outside of the turning wheel are four 
@@ -351,6 +351,24 @@ described in detail in the following paragraph.
   Immediately above the headphone socket is a lanyard loop and the microphone.
   }
   %
+  \opt{fuze}{
+  Hold the \dap{} with the controls on the bottom and the screen on the top. The main
+  controls are a scroll wheel with four clickable points and a button in the centre; pressing
+  this centre button functions as \ButtonSelect{}. Going clockwise from the top, the clickable
+  points on the wheel are the \ButtonUp{}, \ButtonRight{}, \ButtonDown{}, and \ButtonLeft{}
+  buttons. Turning the wheel clockwise is \ButtonScrollFwd{}, and turning it counter-clockwise
+  is \ButtonScrollBack{}. Immediately above and to the right of the wheel is the \ButtonHome{}
+  button.
+
+  On the lower left of the unit is a slot for inserting microSD cards. Immediately below that is
+  the opening for the microphone.
+
+  On the bottom of the unit is the connector for connecting a USB cable and the headphone jack.
+  On the lower right hand side of the unit is a two-way switch. Pressing this switch up acts as
+  \ButtonPower{}, and clicking it down until it locks acts as the \ButtonHold{} switch. When the
+  \ButtonHold{} switch is on, none of the other buttons have any effect.
+  }
+  %
   \opt{clip}{
   Hold the \dap{} with the controls on the bottom and the screen on the top. The main
   controls are a four-way pad with a button in the centre; pressing this centre button